ramstein-dh
Retro Guru
Just wondering how you guage the 5nm torque by hand?
I don't have a torque wrench.
Also should the gap close completley?
it tighten either one at a time bit by bit but when i tighten one the other goes loose and so on
and they never actually fully tighten until the gap closes on the lowers?
I don't have a torque wrench.
Also should the gap close completley?
it tighten either one at a time bit by bit but when i tighten one the other goes loose and so on
and they never actually fully tighten until the gap closes on the lowers?