troje Rocky Mountain Fan Feedback View May 4, 2013 #1 Did the original M950 front mech come in a top pull and a bottom pull version? Or, similar to the modern mechs, does it fit both setups? I've checked the archive, but couldn't finds any resolution here...
Did the original M950 front mech come in a top pull and a bottom pull version? Or, similar to the modern mechs, does it fit both setups? I've checked the archive, but couldn't finds any resolution here...
troje Rocky Mountain Fan Feedback View May 4, 2013 #2 I could have answered this myself. :facepalm: Here I have two FD-M950 front mechs, pictured from above. The left one is bottom pull, the right one is top pull. None of them I can use... :?
I could have answered this myself. :facepalm: Here I have two FD-M950 front mechs, pictured from above. The left one is bottom pull, the right one is top pull. None of them I can use... :?
troje Rocky Mountain Fan Feedback View May 4, 2013 #4 I need a top pull, 28.6 version. Now I have a top pull version, but it's too wide. And I have a narrow one, but it's down pull...
I need a top pull, 28.6 version. Now I have a top pull version, but it's too wide. And I have a narrow one, but it's down pull...
FluffyChicken Archivist Retrobike Rider Feedback View May 4, 2013 #5 Is there a circlip on them holding the 'pull direction' bit on, if so flick them off and switch them over. I know some do, but don't have an M950 to look at.
Is there a circlip on them holding the 'pull direction' bit on, if so flick them off and switch them over. I know some do, but don't have an M950 to look at.
troje Rocky Mountain Fan Feedback View May 4, 2013 #6 Yeah, I might give that a try. Either it works but more likely I mess up two good front mechs