Retrobike Touring.

Re:

I’d put the straps under the cables if possible. Should be ok and then the cables won’t scratch the frame too.
 
Hi i use liner cable bit like the liner used for Klein Internal frame routing
for exposed cables on top tube .
And other areas try i to get Velcro straps under the cables..
Like ft mech cable routing on seat tube
 
Looks like a wing suit.

Fully enclosed cables are the way to go for lots of reasons including this. Easy to do with a few cable ties.
 
fiendish feet":d5zniqf6 said:
Hi i use liner cable bit like the liner used for Klein Internal frame routing
for exposed cables on top tube .
2mm id pfte tubing is what i'd use, run it as close as you can to the bosses (so only 3-5mm exposed at each end) should be crush resistant enough with the load distributed over that sort of length!

With individual straps i'd probably use something like a short section of outer under the strap.

I'll be doing a bit of offroad bivvying next year due to some pretty major lifestyle changes, so if theres nothing else on, i'll be off.
 
Your avatar makes me smile
Used to bump in to Roland in 89-91
On the dance floors off local Acid house party's
:LOL: Great days
One night he was dancing next to three umperlumpers
and a giraffe ....
 
I tried frame bags (on my identical P7) and gave up due to them rubbing feet etc - but a pannier rack fits well, and I have also run a Carradice saddlebag.
 
Re:

Thanks all, think I’m going er, fully sheathed, with some new Jagwire cable outers :D

....Wing suit, cheek....... :cool:
 
Back
Top