bottom bracket help needed
- Thread starter ewanm77
- Start date
- Feedback
- View
73 shell 125mm long if I'm reading right ?
- Feedback
- View
quick search and the T means it has the axle stopper (that black ring) and E means it's for an e-type mech which mounts on the bottom bracket, hence the 73+3)
which makes it a bit harder
http://www.vpcomponents.com/newen/produ ... php?id=240
124.5 is near enough to a rounded of 125mm version
which makes it a bit harder
http://www.vpcomponents.com/newen/produ ... php?id=240
124.5 is near enough to a rounded of 125mm version
- Feedback
- View
you could use a 73-125 one, but you still have to find it.
It may be easier to look for a 127.5 length (a bit wider on the drive side) or if you have 2.5mm to play with on the none drive side then a 122.5 length.
Might just be worth less hassle getting a new crank and bottom bracket setup
someone might come along and know
It may be easier to look for a 127.5 length (a bit wider on the drive side) or if you have 2.5mm to play with on the none drive side then a 122.5 length.
Might just be worth less hassle getting a new crank and bottom bracket setup
someone might come along and know
