Wheel spindle sizes

[Ugo51]

Hi everybody,

I'm looking for a new rear spindle for my Peugeot. It's a 126mm hub.
Do I just measure my current spindle end to end?
I see most spindles are offered as 145, 150, or 155mm but it looks mine is substantially longer. Is there a specific way to measure it, or is it simply its length, end to end?

Cheers

 

[hamster]

You need the OLN length plus most of the dropout thickness - so 126mm + 2x5mm = 135mm. Most QRs have recesses in them to take up a little extra length.
If you can't get them tight you may need to saw the tip off. Make sure you do this with a cone on the axle and then undo it after sawing and filing the end - it will clean the thread up.

 

[Ugo51]

Re:

Thanks.

I just realized I should have pointed out it's not QR. That's why mine are so much longer, because there has to be room for the nut on both sides.
I guess 155mm would do then.

I found this, 175mm long, but maybe it's a bit of an over reaction
https://www.swinnertoncycles.co.uk/whee ... McQAvD_BwE

 

[hamster]

That will do. Try to use the existing cones as the aftermarket ones may not have the right curvature (or sealing detail).

You can always take a hacksaw to it.

 

[Ugo51]

Re:

I'm hoping they do. One of my cones needs replacing.