Various Hope Parts - Last shot before ebay!

[boxxer]

Maybe not proper retro yet but.....

Original Hope Big Un laced to Mavic 521 CD (96) - Front - 32 Hole Blue 20mm bolt thu. Takes 5 Bolt disk - could be run as a rim brake if you wanted £50

Original Hope Big Un Laced to Mavic 521 (01) - Front - 36 Hole Blue 20mm bolt thru. Takes 5 Bolt disk - could be run as a rim brake if you wanted £50

Hope Big Un QR conversion with bearings and axle ends - nice bit of Kit, lets you run a QR Big Un normally (I went the other way) £10 Inc Post

Hope Rear axle - 135 for Hope XC, Sport and Ti-Glide Hubs £10 Sold Pending Payment

Hope C2 caliper half for 74mm post mount - no piston but difficult to lay hands on these anymore..... £10

Hope M4 #3 Caliper Half (I.S.) comes with Pistons and thats about it £10

Hope Rotors - £7 Each
Hope E4 / M4 185 6Bolt

Hope E4 / M4 205 5Bolt

Mono M4 200 5Bolt

AC RH Crank - worn but well usable - £15

AC DH Ring 44 Tooth - £9 or £20 for crank and ring

OEM SPD Style pedals - little use - OEM on 96/97 Marin B17 - £10

LX Front Mech 31.8 Bottom Pull - Swap for top pull in same diameter or £7

 

[The Ken]

Hope Big Un QR conversion with bearings and axle ends - nice bit of Kit and lets you run a big un normally (I went the other way) £12 Inc Post

Do you have a picture of this, and some measurements? I'm looking to Frankenstein an much older hope hub into a QR version.

 

[boxxer]

If you can wait till Monday I can have photos.....

 

[The Ken]

no problem, been waiting a few years for the right bits to turn up.

 

[The Ken]

no problem, been waiting a few years for the right bits to turn up.

 

[nporternz]

i'm looking for a matching hope brake to go on a yeti dh4 from 98!!

would that be the one you have??? what mount is it for?

 

[Dr.Robotnik]

Front Hope C2 with #3 Caliper and Sport Lever, bought new 1998 to go on my B17 and been with me ever since. Pads have a lot of life left, usual marks from 11 years of use - various rotors to choose from in 5 or 6 bolt £35 Inc Postage

Original Hope Big Un laced to Mavic 121 (96) - Front - 32 Hole Blue 20mm bolt thu. Takes 5 Bolt disk - could be run as a rim brake if you wanted £60 Inc Postage

Hope Big Un QR conversion with bearings and axle ends - nice bit of Kit and lets you run a big un normally (I went the other way) £12 Inc Post

Hope Rear axle - 135 for Hope XC, Sport and Ti-Glide Hubs £10 Inc Post

Hope C2 calipe half for 74mm post mount - no piston but difficult to lay hands on these anymore..... £12.50 inc Post

I am interested in the above items, please pm when you post pictures.

 

[boxxer]

Will be home to get pics tomorrow.......

Number 3 is International Standard, depending on the fork / mount you have.

Will PM you all when the pics are up

 

[boxxer]

Pics Up

 

[The Ken]

that bigun axel isn't what I'm after, thanks anyway.