SORTED: Manitou 2 / 3 (or 4??) 1 ¼" threaded steerer

[regan_ev]

Looking for a 1 ¼" Manitou crown because I've just bought some more M2 which I'm gonna fit to the girlfriend's AM DX if I can find a suitable crown. If not, I'll just re-sell, but really want to make these fit.

I need a 13.5 - 14cm length with threads from about 11.5 up.

What are the chances??

I've recently spent on a NOS headset and stem, so only 1 ¼" will do.

Thanks.

 

[Retro Spud]

Re:

Hi Regan

Just seen your post and I can help yah.

Got an M2 crown exactly 140mm, threads start from 95mm

And its inch and quarter of course. Might actually fit the bill without any work needed.

It came on a set of forks but was way to small to be of use



Spud

 

[regan_ev]

Re: Re:

Hi Regan

Just seen your post and I can help yah.

Got an M2 crown exactly 140mm, threads start from 95mm

And its inch and quarter of course. Might actually fit the bill without any work needed.

It came on a set of forks but was way to small to be of use

Spud

Love you buddy!

I'll drop you a PM

 

[RockiMtn]

Re: Manitou 2 / 3 (or 4??) 1 ¼" threaded steerer

if that doesn't work out, i have a NOS one:
viewtopic.php?f=2&t=349872

 

[regan_ev]

Re: Manitou 2 / 3 (or 4??) 1 ¼" threaded steerer

if that doesn't work out, i have a NOS one:
viewtopic.php?f=2&t=349872

Thanks for that - I'm sure I looked at your ad a while back but it's too long. Pity though. I even looked to see if I could make it work as an Ahead-type by chopping threaded portion off but then it'd be too short

GLWS and thanks again.

Spud's steerer should be absolutely perfect