hi guys,
this is my raleigh sensor build........
bought it for a fiver from the tip. wicked.
stripped it down
performed a few mods, namely snapped off and filed down any cable mounts then sent it off to a guy to get some welding and trimming done. Had the brake mount holes welded up, bottle boss holes smoothed and welded up. Had mud guard mounts cut off the forks and dropouts as well as the rear mech hanger ground off and the hole in the dropout extended to allow adjustment of chain tension.
then sent it off for powder coating
ordered a load of parts
then assembled it all!
its not fixed by the way, has a brake and has two gears....... but no cables and no hassle.....
just what i was after! ridden it all over the place!
hope you like
jon
this is my raleigh sensor build........
bought it for a fiver from the tip. wicked.

stripped it down

performed a few mods, namely snapped off and filed down any cable mounts then sent it off to a guy to get some welding and trimming done. Had the brake mount holes welded up, bottle boss holes smoothed and welded up. Had mud guard mounts cut off the forks and dropouts as well as the rear mech hanger ground off and the hole in the dropout extended to allow adjustment of chain tension.
then sent it off for powder coating

ordered a load of parts

then assembled it all!

its not fixed by the way, has a brake and has two gears....... but no cables and no hassle.....
just what i was after! ridden it all over the place!
hope you like
jon