Wanted KONA PROJECT 2 spinner forks

[Oldfellatn3]

Hi

I'm after a pair of good P2's.
Preferably the Spinner ones from 1993 (see pic).
(390mm a to c, 143mm long 1-1/8" threaded steerer).
Ones from the years before this would be OK as well.

Also needed is a good silver Control Center/ Impact headset

Foolishly I sold some a while back!

Thanks

 

[RetroRider_IT]

Hello mate,
I have one P2 available,
it's a '93 model, 390mm a/c with Spinner dropouts as you specified but .... it has a 163mm steerer tube
if you are interested I can take the exact measure for the threaded part and send to you some photos
Best regards

 

[Oldfellatn3]

Hi mate.
Thanks for your reply.
If you don't mind taking the trouble that'd be great.
I have very little wiggle room and it could be a matter of just a couple of mm to make it feasible.
Cheers,
Dan

 

[RetroRider_IT]

Hi mate.
Thanks for your reply.
If you don't mind taking the trouble that'd be great.
I have very little wiggle room and it could be a matter of just a couple of mm to make it feasible.
Cheers,
Dan

Hi Dan,
No problem at all
I Will take measures and I Will send PM with photos in a few minutes
Cheers,
Marco

 

[Spanky22b]

What size frame is it for? If its for a Kona 143mm total steerer length including threads sounds like a 16 inch frame.

The one above at 163mm length sounds like one off a 18 inch frame

 

[Spanky22b]

Just checked on the forks and 143mm steerer length is off a 16 inch frame and they have between 30mm and 32mm of threads, i also compared them to some other P2's off a 18 inch and 20 inch and the threaded length is consistent at 30mm and 32mm.
Just something to consider if you plan to cut them down to size to fit the frame, the longer the steerer length the less threads you'll have left to get a headset to fit properly.

 

[Oldfellatn3]

Hi .
Sorry, I only just saw your posts!
Yes, I'm after the 143mm version

 

[Oldfellatn3]

Bump.
Forks still needed