Frank Wadelton/Enve CX/Gravelcross Frameset for sale

[LeeDevelopment]

Sadly The Development Racing Team is retiring from competing in Cyclocross and Criterium events, therefore we have two frames up for sale, I will do two seperate posts for these.
The first is a cyclocross/gravelcross frameset which is equally at home on the road, Frank Wadelton's geometry sheet has also been attached. The frame utilises an ovalised taper towards the back of the top tube for comfort when shouldering the frame, the cable routing has been placed so that they are kept out of the way for fast dismounting. The frame is made from 7005 tubes and is fully bespoke. Included in this sale is a pair of Enve CX forks, FSA headset and a pair of Hayes Components CX Pro cable operated disk brake calipers. The frame's paint job is a deep magenta with flamboyant metallic glitter. A new frame decal kit will also be supplied.

In addidtion to the design sheet below:
Rear hub spacing 135mm
Seatpost size 27.2
Headtube is tapered

£750.00 plus £35 postage and packing.









quick image upload

 

[wynne]

Aaahhh, my size!!!
Bet that's a little ripper.
In process of flogging a few things so may be in touch.
Out of interest are the decals lacquered over or would they just peel off? Also can you tell me roughly the maximum tyre size that would fit in the rear? I have one of the Mickey generation Supertouch frames and the mud clearance is awful.

Thanks

Rich

 

[LeeDevelopment]

Hi Rich, sorry for the delay. Let me get back to you on Sunday regarding the mud clearance. In regards to the decals with it being a race frame they were not lacquered over. New decals will be included and it's easy to get a local paintshop to lacquer over if you wish.

Lee.

 

[LeeDevelopment]

Re:

Seat stay mud clearance is 2" width, chainstays are a smidge under 2" width

 

[wynne]

Thanks Lee. Lovely looking frame that, I but I'll have to pass as I need to spend my funds replacing some workshop machines dammit.

Rich

 

[LeeDevelopment]

Nee bosh lad