Veedubba
Retro Guru
NOW SOLD, thanks for the interest.
Bit of a sketchy post for now while I go and measure things but basics are:
- Pre production Pace RC35 identified by the step in the carbon weave below the bridge mount
- Black tubular bridge minus the rocker mount
- Refreshed bearing tapes
- New plastic tophat washer (which are not installed)
- No elastomers (could supply some rock hard original ones)
- Uppers in good condition
- Need to go and measure the diameter and length of the steerer.
In overall decent restorable condition, which is what I intended to do (hence some of the new bits) but I have since bought a complete set of later RC35s so these are now surplus to my requirements.
Photos and measurements to follow.
Not sure what these are worth being so early but say, £60 plus postage? Call me out if I'm off the mark!
Bit of a sketchy post for now while I go and measure things but basics are:
- Pre production Pace RC35 identified by the step in the carbon weave below the bridge mount
- Black tubular bridge minus the rocker mount
- Refreshed bearing tapes
- New plastic tophat washer (which are not installed)
- No elastomers (could supply some rock hard original ones)
- Uppers in good condition
- Need to go and measure the diameter and length of the steerer.
In overall decent restorable condition, which is what I intended to do (hence some of the new bits) but I have since bought a complete set of later RC35s so these are now surplus to my requirements.
Photos and measurements to follow.
Not sure what these are worth being so early but say, £60 plus postage? Call me out if I'm off the mark!
that last post was meant as the pm, have really pm'd you now 
