Search results for query: *

Hand made in Halifax really does mean just that. Nice look at how Orange make their frames. Look out for 'motivational' calendars (you can't miss them) and frame alignment. http://www.youtube.com/watch?v=mlIYEdRFQu4&sns=em

I'm planning on making my own frame based around Kona geometry, the size 20 Explosif I have is a little large, so I thought I'd try something smaller - a 98 Cindercone to see if the size / geomtery works for me. Ebay turned up an 18" Eggpant Surpirse 98 Cinder Cone, complete with stuck steat...

All prices are UK Posted, Paypal Gift. I'm also looking for a 9 speed top pull XT from mech 28.6mm low clamp, a Hope Mono Mini rear brake, Hope standard 5mm hose with fittings for front set up and a lowish rise handle bar in silver if you're looking to trade. LX STI units and Mechs - £27...

As per the title; no3 caliper corresponds to a 165mm disc on the rear - has anyone got one? Disc not required. Thanks Andy

Hi, I'm looking for a rear Hope Mono Mini M4 (black caliper with gold caps - pre 2007) set up with a No3 caliper (for 160mm disc). Without disc / pads is OK as I have these, with minimal scratching to the caliper and the lever body if poss. Also looking for the older Hope Mini No3...

Hi, I'm looking for the following; Hope C2 resevoir adjuster top cap (the bit with 'HOPE' machined into the silver top piece with the black hex part attached to screw onto the lever body) I'm looking for a mint or very good one please (would consider a rear lever / rear brake if you're not...

As title - what have you got?

Hi, I'm looking for a rear (that's LH for anyone outside the UK!!) Hope Mini / M4 lever body (the black ones). New old stock would be perfect or with as little scratching as possible (they usually get damaged when bikes are turned upside down). Hope no longer do them, would consider a...

Seeing mikesnowdons thread on updating his Cinder Cone (Original thread: http://www.retrobike.co.uk/forum/viewto ... highlight=) inspired me to do something similar with my Caldera. I wanted a disc mount and sliding dropout (to run an Alfine set up), so I set about pricing up getting it...

Hi I'm looking for the following; 6mm hose for the old Hope disc setups, ideally new, in black and enough to do a rear brake (2 meters worth). All modern hose seems to be 5mm.. Resevoir adjuster cap - the cap with the pump up adjuster, these are silver with 'hope' machined in and are...

Hi, As the title says, looking for a P2 with a nice long 1 1/8 unthreaded steerer in 440mm a-c (suspension geometry correct style). Cosmetic condition not important, disc mounts would be a bonus, but not essential. Thanks Andy

Hi, I'm looking for a Hope C2 wavy disc, 180mm or 160mm, I think they made them briefly before the Mini was launched. (1999?) They're wavy (no, really!) but they don't have any holes like the Mini version. Could swap a standard round C2 disc (180mm) if you need a repacement. Thanks...

Hi, I'm trying to breath some life back into my old Kona Caldera, so I'm looking for a new rear wheel. Ideally I'd like a grey Mavic 317 disc rim 36h (circa 2000) and a black Hope XC rear hub with 6 bolt disc fitting (again 36h), if they're built into a wheel that would be perfect but...