Search results for query: *

I’ve had to damage the LH crank arm on my Cannondale super V 900 project when removing the bottom bracket. Does anyone have a spare? 175mm, the bike is 1995 Thanks Rich

I could do with a cannondale headshok stem for a bike I'm building for my son, 120mm or less if possible? condition not too important Thanks Rich

Does anyone have a picture of the correct stem cap for a 1996 GT Zaskar, there seem to be a few different versions Thanks

I’ve just discovered that the fr mech on my Zaskar project is worn out (pivots loose & floppy) does anyone have a spare? 31.8 clamp/bottom pull XT Thanks

I have some decals to put on my 1996 Zaskar, but could do with a good photo or information on where they should go. Thanks Rich

FR & RR brakes removed from my bike, not needed as I am fitting V brakes. They seemed to work, but I only tested them round my drive, I seem to have all the fittings & instructions, will need bleeding on the rear as I had to remove the hose to get them off my bike. Pads seem good, but some...

I collecting a few bits for my zaskar build, it’s going to be rigid/xt, but i’m Not quite sure about a few parts, how long was the stem on a 18” frame? what grips were fitted?& what seat post clamp did the bike have? I’m also not sure what headset to fit that is age specific. Thanks

I’ve just collected my frame after having the yellow coating removed & the bare frame looks excellent. Now to start polishing & I need some decals.

Looking for a fork for my zaskar project if anyone can help?

I’ve bought a 1996 GT Zaskar off the original owner, it came with rigid forks when he bought it & I would like to return it to std. Are all the gt forks the same with 1 1/8” steerer or do I need a zaskar fork? Also can I strip the paint and polish the frame? Thanks

The previous owner of my bike removed the LH brake lever (to use the cable on his garage door!) I have the lever, but not much else. I'm after the whole LH lever/shifter (does not have to work) or the brake cable barrel adjuster, and lever mounting screws & fixings there are no numbers on the...

I've been give a 92 bear valley that must have been used little & then stored a long time? after a full strip it seems that the bottom bracket is needing replacement, no play, but feels rough. It's a shimano BB-CS20 BC1.37x24 about 124mm in length and screws in from the left with the plastic...

I'm after a HB-M737 XT front hub if anyone has one? Thanks Rich

I'm after a 27.2mm seat post race face XY, XYO if anyone has got one? or anything from 97/98? Thanks Rich

I have a 99 orange P7 that I'm building, but could do with the original specs (stem size, group set etc) can any one help or post a photo Thanks

I've just bought an orange p7 & could do with the original forks, the are the F14 type With the brakes on the back of the forks. Thanks Rich