Search results for query: *

thanks just seen this

my mate got alloy frame shot blasted he then left it his shed for a while you could little specs of rust where shot had embedded into it left a dull an rough finish no good for polishing i think you need walnut bead or soda blastiing if you intended to polish it

Looking for some forks that can go on gt dhi wall hanger It either needs triple clamps are big travel single crowns

I have 165 I m.looking for 203mm Not sure will add a photo

Looking to trade two 165mm rotors for some 203mm.

i ll take these if possible

Success I have 3 bb tools but they are all missing the plastic cap

So the bolt needs to be the same pitch as the bb thread an it screws all the through My bb thread is approx m12 but I can't get anything bigger than an m8 bolt through the length of the axle as there is a step inside it

This is what happened when I tried the 5p

What stops the bolt from pushing out

This was over grey primer The cloudiness is my hand print from picking it up

i ve used it over grey primer an its not bad to be fair , what you could do is is give it a coat of 2k laquer with some silver flake mixed in

i tried the 5p trick an its bent the coin an pushed it inside the axle i going to try a different way using a steel plate bolted through the crank extractor an a bearing puller

Attempted to remove this crank because the axle is hollow when I screw the tool in its not pushing against anything

theres a full fork just been listed for sale { not mine}

i think someone on here was looking for monsters @Stretch79

Not sure it was a lot hassle to get them. I was thinking if I gave you the part number you might have more luck matching them up

Yes please if still available

I have a set of brand new startos seals in my loft If I remember correct they have different part numbers to the old ones The seals come in the threaded alloy cup I emailed the guy that made the stratos forks his name is mete

The one I posted is 1.0 pitch