Recent content by simon_adams_uk

Hello, A loose headset on my C16R has revealed itself to be due to a thoroughly mangled steerer on the original F7 forks. So, does anyone have a spare set of F7 forks available? - 1" diameter - ideally threaded (but threadless ok) - min length 150mm - colour ideally dark green, black or...

PM sent...

Another happy buyer here - excellent communication, good packaging, very quick posting. Thanks!

I'll take the Coda levers please - will you accept £8? PM also sent.

PM sent re: LX cantis...

I'm looking for either a Rock Shox SID/??? >190mm 1" threadless crown+steerer OR a Rock Shox SID/??? >155mm 1" threaded crown+steerer. This is either to buy or to swap for a Rock Shox SID 175mm 1" threadless crown+steerer. I'm happy to consider other crown+steerer assemblies that are...

I've got: Rock Shox SID 175mm 1" threadless crown+steerer I'd like: Rock Shox SID/??? >190mm 1" threadless crown+steerer OR I'd like: Rock Shox SID/??? >155mm 1" threaded crown+steerer [Am happy to consider other crown+steerer assemblies that are based on the same stanchion diameters...

PM sent re: Judy XCs...

I bought a pair of Halson forks (the completely black version with angular brake arch) in 2007 with completely dead elastomers. After quite a bit of playing around I found that Manitou replacement elastomers/springs can be (just about) fitted instead - I know Vitorzip had some Manitou...

Two questions: 1) with a threaded headset, is it wrong to use a spacer between the top locknut and bearing cup nut? (I can just about cope aesthetically - wanted to check it's ok mechanically. Can't be bothered to cut 5mm off the steerer tube so fancied using a spacer) 2) what's the best...

Hello all, A bit of a long shot this... I need to add another 5mm or so onto some new forks I've got. Does anyone have a die (and holder) for a 1" 24tpi thread? Am happy to pay P&P costs for sending it to me (and back again!). [By the way, I've tried the local LBSs who want a...

PM sent re: elastomer kit...

Hello, I'm looking for some replacement springs (or indeed elastomers) for a recently acquired Halson inversion fork. The only constraints are: total length less than 210mm and outside diameter between 20-25mm. What have people got? Not looking to spend a fortune by the way :O)...

I'm keen to have them (does that make me 1st or 2nd in line?) The only proviso is that the steerer is at least 160mm (looks it) and that they're in good working order (are there any known major faults?). Simon

Too short (again)! Is the steerer replacable (& do you have one which is longer)? S