Recent content by rc200

Re: x -lite stem SOLD 2012

Re: x-lite stem SOLD X-LITE stem sold in 2012

Re: 96 frame would have a 1" headtube. 99 onwards ha a rear disc mount. My 99 P7 was repaired and resprayed by orange and had those decals fitted which were then the current ones, this was in 2002ish

Sorry, only saw the 1st picture and line of text when I looked this morning, it was early, I must have still been asleep

Pace did update frames and offered to add an F8 disc mount to my F6

Frame no. should start F* (6/7/8). Looks like an F6 that's had an Fi disc mount added. F8's had triple butted top and down tubes and butted head tube and bottom bracket shell and seat stay disc mount and canti mounts. F7's had double butted top and down tubes, can't remember what the bb shell...

I test rode one in '95 borrowed from evolution imports, it was yellow with black decals and preproduction pace rc35 mxcd forks.

Re: I had an f5 from new, down tube decals were pace racing (pace in white & racing in red) fitted on the non milled part of the downtube right behind the head tube. Seat tube decals were the same style but I think they were smaller and fitted at the very top of the seat tube.

Re: You're missing these

Re: I don't have a bb out of a bike to look at it, but if the sleeve is 48mm, the raised section of the axle should be 48mm bearings are 7mm each which adds up to the 62mm total width you have so it should be ok. Are you fitting the bb assembled as per the picture of the red one? This is how...

Re: Totally agree with Konsta, without the sleeve you will wreck the bearings. My spare sleeve measures 48.00mm. Bearing spacing / sleeve width is the same on my 68mm & 73mm hope bb's, the extra width for the 73mm version is 2.5mm additional width in each of the cups.

Re: I think all 1 inch head tubes have a pair of vertical ribs running the length of the tube that the top tube and downtube are welded to, 1 1/8 head tubes don't have this, they're just circular in cross section

Re: Seat post diameter should be 29.4mm not 28.4mm

Are you sure its a ti glide, never seen one with two different sized bearings.

Re: Looks like an F4 to me, that's the seat clamp collar I was thinking of that is squarer in the pinch bolt area.