Recent content by raveydavey

so i too was able to benefit from the kindness and generosity of mdivineng when i bought the wrong replacement pawl for my ti glide freehub, as it actually turned out to be an XC! long story short i now have a spare 4.69mm pawl (the one on the left in the picture below) so if anybody is missing...

what are the unstickered red forks 5th from the left please?

interested in these if available

Forks are now ‘sold pending payment’, that’s all the bits I have

more pics

Hi folks Here are a few bits I keep looking at but am never going to do anything with! Paypal gift or you pay the fees. Postage is included Royal Mail proof of delivery or you can collect. Hope 36 hole front hub 100mm and rear hub 135mm standard 9mm Q/R in red, front hub is slightly more faded...

i'll take those Tioga Factory XCs off you please!

hi can i take these please

Re: yellow bottle cages please, pm incoming

Re: nice one thanks for the heads up, think I've inadvertently bought one off him on ebay!!! username rh.plus.peter ?!

Re: I've tried threading a steel one before it's a nightmare of a job. I was gonna try threading this alloy one but was advised against it, hence the offer of swapping! I believe the RST steerers are the same fit as Marzocchi but I've not tried it yet.

I am after a Marzocchi 1"1/8th THREADED, steel or alloy steerer (preferably alloy), ideally with crown to fit some 1997/8 Z2's. The steerer needs to be 180mm long to fit my 20" frame with big head tube! I have the following 1"1/8th AHEAD alloy steerer and crown to swap if it helps?!

Re: I've just found the hub this fits on so it's not for sale any more!

Re: just measured it and A-C is 455mm, so I was a bit out!

Re: @Matley 64 - yes i could send to Italy but postage will cost more. pm me if you are still interested. @dandy1 - they are 80mm travel so I reckon it will be 420mm a-c but I will check for you