Jimmi's latest activity

It’s defo going the right way, the main problem is trying to keep the BB tool in place while I administer the breaker bar. Normally I’d...

Have you tried soaking it with penetrant?

Make sure your turning it the right way! The threads are opposite on opposing sides. From google: "The common threading for bottom...

Ive come on here to vent! I just got my hands on a 90s Stumpjumer adorned with loads of lovely bits, but the bottom bracket is holding...

Some headsets have a rubber seal to prevent the ingress of water. It can be on the top of the top assembly, or the bottom of the bottom...

So …. The crown race bearing was upside down🙃! Thanks for all the help, lesson learned.

When you say seal jamming, which part is the seal?

Also, check that any "play" is actually in the headset by placing a finger around the top race on the headset and rocking the bike back...

https://www.parktool.com/en-int/blog/repair-help/threaded-headset-service Sections 6-8 might help you.

e If I’m honest I didn’t check it prior to stripping it. It wasn’t my bike, it had been sitting in someone’s garage for years so I paid...

Yes there would be play, but if it wasn't there before you stripped it......

Have you put it back together properly? Everything in the correct order?

Caged bearings in upside down? Seal jammed somewhere?

As far as I know, I’ll have to take it apart and check it. This is new ground for me, if it was worn out would there be play in it like...

I’ve cleaned and re greased the headset on my 96 Hardrock, but if I pull the front brake there’s play in it. If I tighten it to remove...