Recent content by Gregthorne370

Hi all, I'm trying to work out a listing price for my 2014 Mavic Crossmax Enduro 26" wheel set. Front hub is 20mm thru axle, rear is set up as 12x135mm this axle. I have a spare 2012 rear axle (now hard to come by) that I bought from the Netherlands, as well as a 9x135mm qr conversion for the...

Hi, Don't mind at all pal. I'm no longer needing to go and have parts machined up. Which bits are you after though?

And loving the aesthetics of them too... Just like my old D321s that I bought 20 years ago, that were unfortunately stollen about 12 years ago, so a nice bit of nostalgia for me :)

Hey guys, Just to say another massive thank you for helping me out with the parts. Wheels are now built up and ready to roll :)

Yes!!!! Ah mate that would be perfect! 😁😁 Means nothing will be bodged with my the conversion then. Cheers guys, you've really helped me out here

Amazing! Thank you. I ran a tape across mine at work (didn't have verniers) and measures 20mm in length. Seeing as though the larger ID of mine is 15mm, I think I should b able to find a needle bearing inner race of the correct dimensions to insert in to my spacer to reduce the overall...

Hi, thanks for the measurements... definitely helpful. Any chance of a photo of the spacer if it's not too much trouble please? Thanks 👍🏼

That would be great, thanks. And yes, understand what you mean about bearing spacings etc.. should be able to make something work though 👍🏻

Bearing supports are in correct location, just the overall length may be a bit out..but should be easy enough to sort if needed

If you could measure yours and pass them on that would be great, as could get one machined like you say. And yes, will be running a disc. Thanks Greg

Yep, that's the diagram I have... Which shows a similar looking spacer. So hoping it's the right one and won't need to butcher mutch to make it work 🤞🏻

Hi, It's for 6 bolt non-drive side. The internal dimensions are 15mm reducing down to 12 at the end, so does fit nicely over the axle. I have just received in the post a 150mm wide bulb that has the drive side end cap...so my plan is to make a franken hub that uses the 150mm axle, cut down on...

This is another photo of the possible Bulb end cap, but just need confirmation before I pay £30 on a job lot just for to get this spacer

They look like Pro end caps...

Would anyone be able to confirm if this is a Bulb 12mm end cap? May have found one... Thanks