el_Pedr0's latest activity

All of the drivetrain is original apart from the chain, shifter cables and housing. I measured the new chain against the old one when I...

108 links

Front chain ring has 46 Teeth Rear large ring 30 T Middle of bottom bracket to rear hub 427mm (+/- 2mm)

I too noticed the tab - it used to be bent a few degrees more than that, so I've already bent it a bit but any more and I start to...

Screw isn't all the way in the photos because I ve been adjusting it in and out as I've been trying to diagnose, but it has no impact...

Photos attached

The chain tension is pulling the derailleur forwards, but 'forward' in my sense is pulling the b-screw with greater force to the frame...

There is only one hole in the knuckle spring - so no option to vary there. In the tension spring, there are two 'available' holes close...

Yes. Working fine and moving the little tab round on the derailleur

What spring holes?Please could you describe where should I look .

It's all the original kit that came on the bike when I bought it new so I assume that it is designed to go together. I haven't ridden...

I've got an Exage 400LX rear derailleur and the jockey wheel is essentially running directly on top of the largest gear in the rear...

... very, very dry at the moment though - so still don't know whether clearance will be a problem in muddy conditions. (new tyres are...

Went out on the bike yesterday for some very light trail riding and was delighted with the bike. The Nobby Nics feel so much grippier...

Thanks for all your suggestions. Shortlist came down to Nobby Nics and Panaracer Fire. I've taken the risk on clearance and gone for...