Recent content by dinty999

I recall from the silkscreen printing days, the hardness (firmness) of rubber is measured in "shores" so for fine printing we used 100 shore squeegees, and printing over an uneven surface we would need a softer squeegee, so would use a 65 shore squeegee blade,

Work in progress

Seat tube

Head tube, not sure if this one will work or not, let me know

Seat Stays

Looking for a VGC Ritchey Logic EXPERT aheadset for a 1998 SWorks build

Where can I get a full decal set for a 1998 M2 S Works, seen some where on here "the goto guy" but cannot find the post

Cheers, but I found a NOS Shimano Deore XT :)

Getting closer to be finished

That's the one. Didn't realise it was a road stem though.

Hi, I am sure when of you will know, but when was the Easton EM90 stem released, looking for a stem for a mid 90s project and just cannot remember if the EM90 is period?

Sorted now, many thanks

Still waiting to find the right seat clamp, so only put in, but not drop it down to the correct height yet as did not want to mark it as its a NOS XT seatpost :)

Not quite finished, yet, a few weeks away and I'll be done

I am needing a 34.9mm Top Pull M900 front mech, or possibly a M953, it there anything out there?