deelam
Retro Guru
I was hoping to be out tomorrow on a newly-acquired Fisher RS1-PRO but it's not going to happen now
not being much of an oil monkey, I have no experience with these:
Are these MAG20's? I tried to inflate very gently using a lubed needle but the needle only penetrates about 5mm, is this right? I assume the valves are knacked because they leaked immediately. Anyone know A) where I might find valves or service kits and B) a link to some tech info so that I can try and service? Also the bottom pull DX front mech (pictured) is giving me grief. I've never used one with a jubilee-clip type fixing before and it just moves all over the place even fully tightened! The amount of force in the spring seems way too high. Any ideas? Any suggestions greatly appreciated!
Thanks
not being much of an oil monkey, I have no experience with these:
Are these MAG20's? I tried to inflate very gently using a lubed needle but the needle only penetrates about 5mm, is this right? I assume the valves are knacked because they leaked immediately. Anyone know A) where I might find valves or service kits and B) a link to some tech info so that I can try and service? Also the bottom pull DX front mech (pictured) is giving me grief. I've never used one with a jubilee-clip type fixing before and it just moves all over the place even fully tightened! The amount of force in the spring seems way too high. Any ideas? Any suggestions greatly appreciated!
Thanks