WTD - jockey wheel allen screws for M739 mech

mynchiboy

Gold Trader
Feedback
View
I'm looking for the above, if anybody has any in their parts bins? I took the mech apart in order to clean/repaint the cage and the screws have since vanished... :facepalm:

The bolts are about 15mm total length. I'm sure some others from similar Shimano mechs will also fit. Anything out there :?:
 
Re:

Have a pair off a 735rd. Thread on one a bit imperfect but it screws into the plate well enough.

PM me your address and I'll pop in the post.
 
Re: Re:

mdvineng":tavmdgu9 said:
Have a pair off a 735rd. Thread on one a bit imperfect but it screws into the plate well enough.

PM me your address and I'll pop in the post.

Lifesaver - many thanks :D

I'll PM you some details over in a minute..
 
I understand. We certainly didn't measure it the same way. Now I measured the screws just like you. 15.88 and 14.2.
 

Attachments

  • IMG_20200523_175313.webp
    IMG_20200523_175313.webp
    215.3 KB · Views: 137
That's the correct way now!

The 2 about to go in the post were just taken straight off an RD735.

Now posted, well in the red box at least :)
 
Re:

Interesting info chaps and thanks for this!

I knew there was a difference between mechs but thought Shimano would be fairly similar. As far as I can see the extra couple of mm is purely thread, so I can probably file off the difference if needs be.

I guess that means I'm sorted :D
 
Back
Top