I'm looking to buy a Shimano LX Dynamo hub part no. DH-T675 to build up on a spare Mavic 721 disc I've got to make a robust touring wheel.
The problem is that Shimano don't want to publish the dimentions of the flanges anywhere online the, best I can find is in one of there technical manuals which reads as follows:
O.L.D - 100mm
Flange distance - 52.1mm
Offset - 4mm
Hole P.C.D - 70mm
But the DT Swiss Calculator requires flange distance left and right, assuming the flanges are about 2mm think I make it:
Flange distance left 20mm
Flange distance right 24mm
Can anyone confirm or offer alternative values?
Finally when I plug all this into the DT Swiss calculator I make it 251mm spokes on both sides, again can someone confirm this?
The problem is that Shimano don't want to publish the dimentions of the flanges anywhere online the, best I can find is in one of there technical manuals which reads as follows:
O.L.D - 100mm
Flange distance - 52.1mm
Offset - 4mm
Hole P.C.D - 70mm
But the DT Swiss Calculator requires flange distance left and right, assuming the flanges are about 2mm think I make it:
Flange distance left 20mm
Flange distance right 24mm
Can anyone confirm or offer alternative values?
Finally when I plug all this into the DT Swiss calculator I make it 251mm spokes on both sides, again can someone confirm this?