SilverMerlin
Retro Newbie
I am after a pair of front wheel axle end caps. They are the type that use a small 2mm hex key compatible grub/set screw to hold in place. The measurements are (these may be a mm or two out)
- outer diameter 26mm in diameter
- inner diameter 10mm(where the axle fits)
- height 10mm.
Picture of one the end caps is below:
If anyone can point me in the right direction that would be very much appreciated.
- outer diameter 26mm in diameter
- inner diameter 10mm(where the axle fits)
- height 10mm.
Picture of one the end caps is below:
If anyone can point me in the right direction that would be very much appreciated.
