Yes i have some raceface evolve dh cranks and i havent been able to get them setup properly. On maintenence today i realised one the the plastic bits which sits inside the bearing and 'guies' the axle through, is crushed into the cup slighlty.
This is with a 68mm shell and i measured the amount of spacer i have on there, its 80mm between the 2 cups! Soooo im guessing thats not right, right?
I had suspicion with these before but managed to get them setup ok on the other frame i had them on but dont think it will happen on this frame.
All being said and done though, should it matter? I thought you could space out a bb to whatever? (Although obviously its not ideal and not best practice, just theoretical for me as if they are 83mm i will probably be looking for others).