These wheels came with a frame and forks I've just bought.
The hubs are Goldtec, a Draco Pro Competition 15mm bolt through front and a Pro Competition SS rear. The rims are made by Ryde and are set up to run tubeless. Spokes are black double butted. They spin smoothly, the front pretty much bang on and seems ding-free, the rear has a couple of kicks and a little up and down in it and two shallow dings on the drive side.
I haven't used these since they arrived, but I have replaced all the bearings and stripped and cleaned them!
The end of the axle on the freehub side has a tiny crack about 3mm long where the hex for an allen key was machined into it, you can see it in the pics. It's beneath the end cap so isn't an issue. The pawls were cleaned and re-greased.
The rear hub is singlespeed specific, it won't take a normal cassette and It's 135mm with a quick release and has a Ryde rim 24mm wide with symmetrical spokes.
The front hub is 15mm bolt through and the Ryde rim is 28mm wide with an asymmetric spoke pattern.
They're light wheels! The front is 840g and the rear is 850g according to the kitchen scales (without tyres obviously)
I will include tubeless valves and the tyres that came with them, a 2.35 Nobby Nic for the front and a 2.25 NN for the rear, both with plenty life left.
Looking for £150 posted PP gift UK or best offer for these, need them gone, so if they’re of interest, get in touch
The hubs are Goldtec, a Draco Pro Competition 15mm bolt through front and a Pro Competition SS rear. The rims are made by Ryde and are set up to run tubeless. Spokes are black double butted. They spin smoothly, the front pretty much bang on and seems ding-free, the rear has a couple of kicks and a little up and down in it and two shallow dings on the drive side.
I haven't used these since they arrived, but I have replaced all the bearings and stripped and cleaned them!
The end of the axle on the freehub side has a tiny crack about 3mm long where the hex for an allen key was machined into it, you can see it in the pics. It's beneath the end cap so isn't an issue. The pawls were cleaned and re-greased.
The rear hub is singlespeed specific, it won't take a normal cassette and It's 135mm with a quick release and has a Ryde rim 24mm wide with symmetrical spokes.
The front hub is 15mm bolt through and the Ryde rim is 28mm wide with an asymmetric spoke pattern.
They're light wheels! The front is 840g and the rear is 850g according to the kitchen scales (without tyres obviously)
I will include tubeless valves and the tyres that came with them, a 2.35 Nobby Nic for the front and a 2.25 NN for the rear, both with plenty life left.
Looking for £150 posted PP gift UK or best offer for these, need them gone, so if they’re of interest, get in touch
