I am not particularly familiar with cantis and am struggling to set-up a set.
The biggest issue is that the brake blocks are fitted by clamping onto a 'post' which comes out of the centre of the rear (!) of the block. They are this type: http://www.slanecycles.com/aztec-contro ... 18727.html
After a couple of hours, I can't really see a failsafe way to align these blocks. Are they really as much of a pain in the proverbial as they seem?
To add insult to injury, I also can't really tighten the securing nuts enough to stop the pads rotating.
Getting these right is the final job on this build and so I would be grateful for any words of wisdom!
The biggest issue is that the brake blocks are fitted by clamping onto a 'post' which comes out of the centre of the rear (!) of the block. They are this type: http://www.slanecycles.com/aztec-contro ... 18727.html
After a couple of hours, I can't really see a failsafe way to align these blocks. Are they really as much of a pain in the proverbial as they seem?
To add insult to injury, I also can't really tighten the securing nuts enough to stop the pads rotating.
Getting these right is the final job on this build and so I would be grateful for any words of wisdom!