Bearings for my TNT hubs

I've got 2 TNT titanium hubs, but the bearings are toooooo old :cry: .
I want to replace them but, impossible to find such bearings in France.
I think, it's the same for the old carbon NUKE-PROOF hubs or the Bullseyes hubs.
If someone know the nomenclature of this specific bearings ? :?

Thanks

theres normally a code written on the outside of the bearing seal. if you google that code it might tell you new bearings that are the same size.

24pouces":3u4ihkzp said:

I've got 2 TNT titanium hubs, but the bearings are toooooo old :cry: .
I want to replace them but, impossible to find such bearings in France.
I think, it's the same for the old carbon NUKE-PROOF hubs or the Bullseyes hubs.
If someone know the nomenclature of this specific bearings ? :?
Thanks

Click to expand...

I had a Nuke Proof carbon hub with worn-out bearings, and was advised that there was no possibility of replacing them via the cycle trade. But I went to a specialist bearings dealer, and they were able to identify them and order me some, which cost £22.

scant":3s5373el said:

theres normally a code written on the outside of the bearing seal. if you google that code it might tell you new bearings that are the same size.

Click to expand...

The problem is, no code written on the side. It's the reason why I'm looking for someone who knows that code
Antholy : when you have the bearings, Can you tell me the code?

The bearing can be measured and then identified. The inner diameter of the bearing race where the axle slides though the bearing is the first dimension, the overall diameter is second dimension and the width of the bearing is the third.
The bearing will no doubt have two rubber seals to protect the bearing from the elements so will have a code of '2RS' at the end. Running tolerance will be 'C3' for a cycle bearing. Most cycle hubs use bearing code 6001-2RS-C3 or 6002.

Common/likely bearing codes with sizes:-

6000-2rs-c3 10.000 x 26.000 x 8.000mm
6001-2rs-c3 12.000 x 28.000 x 8.000mm
6002 2rs-c3 15.000 x 32.000 x 9.000mm

Anthony":2rbbinzk said:

24pouces":2rbbinzk said:

I've got 2 TNT titanium hubs, but the bearings are toooooo old :cry: .
I want to replace them but, impossible to find such bearings in France.
I think, it's the same for the old carbon NUKE-PROOF hubs or the Bullseyes hubs.
If someone know the nomenclature of this specific bearings ? :?
Thanks

Click to expand...

I had a Nuke Proof carbon hub with worn-out bearings, and was advised that there was no possibility of replacing them via the cycle trade. But I went to a specialist bearings dealer, and they were able to identify them and order me some, which cost £22.

Click to expand...

I did the same with my White industries rear hub, i knocked a bearing out and the guy matched them up, he had them in stock though, they were £7 each but he gave me them for a fiver each, he couldn't beleive such high quality bearings were for a bycycle hub :roll: