Recent content by will16

The frame is in Abingdon, Oxfordshire.

Hi, I have a 198? Dawes Warwick frame, Reynolds 500 steel tubing. It was one of Dawes hand built series. In 25" frame size. No bottom bracket, or forks. Suits 700C wheels a treat. It has been sat in a garden for 15+ years, and has some rust on it. The seat post is stuck in the frame as...

Bump, Will swap one mech for short drop brake caliper.

Hi guys, For my single speed project I need a short drop brake caliper (Front). The drop needs to be about 40mm. Looking to spend about £6-£7 plus postage. Many Thanks, Will

bump

Thanks for the info, very helpful :)

For Sale, I beleive early 80's Shimano 600 Gear set. I can sell it complete, or in parts. Its a complete matching set. I can provide more photos if needed. Rear Derailleur- It is quite dirty, I've given it a quick wipe over, but needs a proper clean. I beleive its in working order. One...

Hi Guys, I wanted a bike that I could scoot about on in any weather, without damaging my Peugeot Triathlon. I had a donor bike, a Dawes Warick, that I will transplant most of the parts on to my newly aquired Raleigh Equipe. I will respray eventually, but its way too cold to get a good...

Hi guys, Many Thanks for tge offers! How good a condition are these in? I don't want a mint one, and a beater would be fine. What prices you talking aswell? Many Thanks, Will

Bump........

Hi guys, I'm looking for a used 20 to 22" frame. Has to be vintage/retro! I'm not looking for anything in particular. Preferably lightweight. Any colour, except pink! If anyone is wanting to swap for a 25 1/2" Dawes Warwick Hand Built frame, I'm up for that. I'm in the Oxfordshire Area...

Hi guys, looked through some photos and found this one: Uploaded with ImageShack.us Look at the bottom. Its hard to tell, but it foes look like threads are showing and part of the cap is sticking out of the lock nut. Any ideas??

Hi guys, thanks for your ideas so far! -1988_ben The bearings are in cages, and it's all the original parts. I'm sure it went back together as it was before. It does spin ok also. -dave72 When you say spindle, do you mean the axle? If so the longer side of the axle is on the drive...

Hi all, I have a question for you! I'm rebuilding a 1988 Peugeot Triathlon Road Bike and have just rebuilt the bottom bracket. When I screwed the end cap in it sticks out and threads are still showing! Is this correct??, I've attached pictures to show what I mean. Thanks, Will

Looking at those part specs, mine are differant. Mine is a 12 speed, has differant Mavic rims, 501 tubing, and 700c x 20c tires.