Big_Jon_93
Dirt Disciple
Hello. I have some really nice Shimano hubs from the 90's I think. They only have Shimano stamped on them, so I don't know what series they belong to. I tried at SJS cycles about getting some cones but they don't stock any the right size. I was just wondering if anyone had any cones that might fit.
The cone I need is like the drawing (See attachment). Measurements not 100% accurate, just what I measured with micrometers. Of course it is threaded in the middle of the cone, I just haven't drawn it. Also it has compression glands/washers on, that sit in that 2.9mm gap. The actual axle it is screwing on to is 8.8mm in diameter. It's for a front axle.
Any help would be much appriciated.
Regards
Jon
The cone I need is like the drawing (See attachment). Measurements not 100% accurate, just what I measured with micrometers. Of course it is threaded in the middle of the cone, I just haven't drawn it. Also it has compression glands/washers on, that sit in that 2.9mm gap. The actual axle it is screwing on to is 8.8mm in diameter. It's for a front axle.
Any help would be much appriciated.
Regards
Jon
