Project "IHNFM" GT Avalanche content.

mikeekim89

Old School Grand Master
So I built a new bike. Because I didn't like any of the other bikes I'd built since my last Zaskar at all.

I did well to be fair.. I got a 1x9 built with only the frame set too that build.. I've had it a while and it has the worst most half assed spray job on it..

The specs are... Out there, at best. :oops:

It works though and from what I tried it as it isn't a awful ride..

Specs are as follows:

Frame: 2002 GT Avlanche 2.0

Fork: Marzocchi Bomber Z4

Headset: WTB Grease Guard
Stem: Ritchey Complite
Handlebar: No name riser
Grips: RF Good and Evil
Barends: N/A

Brakes: Tektro cable Front Disc and Deore Rear V
Brake Pads: Standard
Brake Cables: Shimano
Cantilever cable hangers: N/A
Brake Levers: Shimano and Tektro

Shifters: Deore 9 speed
Front Derailleur: RooX chaindog
Rear Derailleur: Shimano RSX
Derailleur Cables: Shimano
Cassette: Crappy 7 speed
Chain: SRAM I think..
Cranks: STX RC
Crank Bolts: Shimano
Chainrings: STX RC
Chainring bolts: STX RC
Bottom Bracket: Shimano
Pedals: Oddysey

Hub Skewers: Bolt front and QR rear
Rims: No name front and Araya rear
Hubs: Quando front No name rear
Nipples: Unknown
Spokes: Standard
Tyres: Continental
Tubes: Pass

Saddle: Selle San Marco SKN
Seatpost: Lite Stik
Seatpost Binder: I'm not sure

Weight: It's not light :p
 

Attachments

  • photo.JPG
    photo.JPG
    103.7 KB · Views: 774
It's strangely alluring.

I am thinking of going 1 x 8 on my singlespeed zaskar. Chaindog doing hte job ok?
 
I haven't ridden it yet..

I'm not sure if I'm using it right either.

I've got to check if it works right.

I've ridden almost all of my bikes as a 1x7-9 setup.

It's rather easy and very simple.

Setting up a 9 speed shifter too run with a 8 speed road mech and a 7 speed cassette. Not so much..
 
Back
Top