iamcheapskate
Retro Newbie
Part 1
I am taking my Raleigh Quadra apart for an overhaul / sprucing up and have, not unsurprisingly, run into some problems. I pulled one crank arm off with no fuss, but the other is being a sod. I can't seem to thread to crank puller in – its as if it's too big for that side, rather than the threads of the crank are damaged. Anyway, any non-destructive ideas as to how to remove?
Part 2
Since I suspect that the result of part 1 is "destroy", I have already started eyeing up campagnolo cranks. Can i keep the shimano 105 rear derailleur if i go that route?
Ta!
I am taking my Raleigh Quadra apart for an overhaul / sprucing up and have, not unsurprisingly, run into some problems. I pulled one crank arm off with no fuss, but the other is being a sod. I can't seem to thread to crank puller in – its as if it's too big for that side, rather than the threads of the crank are damaged. Anyway, any non-destructive ideas as to how to remove?
Part 2
Since I suspect that the result of part 1 is "destroy", I have already started eyeing up campagnolo cranks. Can i keep the shimano 105 rear derailleur if i go that route?
Ta!