Got a set of XTR M950 hubs the other day, Front is fine, the rear however was notchy when the axle was turned by hand.
Having stripped it down, i found the cones a little on the loose side and the bearing race & cone on the drive side quite pitted. The other side is marked but I think it will run on ok.
Now I'm thinking my options are:
1, find another rear hub (£££)
2, find a M950 rearhub and cone to replace the existing (i'm thinking this will be difficult)
or
3, find another freehub that is compatible with the hub shell and a cone that will fit the axle?
Anyone got any advise?
Having stripped it down, i found the cones a little on the loose side and the bearing race & cone on the drive side quite pitted. The other side is marked but I think it will run on ok.
Now I'm thinking my options are:
1, find another rear hub (£££)
2, find a M950 rearhub and cone to replace the existing (i'm thinking this will be difficult)
or
3, find another freehub that is compatible with the hub shell and a cone that will fit the axle?
Anyone got any advise?
