So close to finishing my first road build... I've learnt a heap stripping and rebuilding this bike, it's close, but I have a problem with the back wheel I feel underqualified to sort out... so am hoping some knowledgeable gent on here will be able to help me.
My old back wheel was aligned perfectly (central in the frame) but the hub and bearings were shot.
I got a great newer pair off this forum but the rear hub sits differently in the frame.
It sits fine in the dropouts, there is no play, but it's just not centered in the frame - like so :
There doesn't seem to be any room for adjustment that I can see, however I think it's something to do with this nut here
that is too far out. It's like this nut needs to be further "inside" the back cassette if you see what I mean.
The other side
So is it a case of loosening one side and tightening the other up?
Sorry to seem like a n00b but as I said this is my first road bike build and I really don't know much about hub adjustment.
Any advice appreciated.