Removing Crown Race without proper tool ??
- Thread starter Hilts
- Start date
- Feedback
- View
/\ /\ /\ /\
Yup, tsall I've ever used too
Yup, tsall I've ever used too
Iwasgoodonce
Old School Grand Master
A stilson wrench (not wench) that opens wide enough and gentle taps with a hammer. Pressure is then being applied more evenly. Screw driver when I couldn't find a large enough stilson though...
rumpfy
BoTY Winner
Someone told me the good advice...if the tool you're using to get the race off is a softer (weaker) metal than the race itself...then you'll be ok.
I use a big, wide, soft (ie: cheap) flathead screwdriver and hammer.
The actually tool you can buy to remove races is bulky and super expensive.
I use a big, wide, soft (ie: cheap) flathead screwdriver and hammer.
The actually tool you can buy to remove races is bulky and super expensive.
