I just bought a rear wheel with hope Ti hub and when I went to fit it I discovered the dropouts didn't meet the axle. If you look at the photos the axle is recessed behind the line of the disk rotor - it would need to be another 15mm at a guess for the dropout to sit on it nicely.
What am I missing here? What's going on? Is there a spacer I didn't get or what? It's going onto a standard MTB dropout (135mm?) - normal anyway. I've also attached Hope's bulb diagram which must be similar - do you think I am missing Item 4 (The non-drive spacer)?
What am I missing here? What's going on? Is there a spacer I didn't get or what? It's going onto a standard MTB dropout (135mm?) - normal anyway. I've also attached Hope's bulb diagram which must be similar - do you think I am missing Item 4 (The non-drive spacer)?