johndeverill
Senior Retro Guru
Re:
No problem, time to make myself a mould then!
No problem, time to make myself a mould then!
For Sale The END! We have stopped! Silicone Springs - elastomers for Manitou/RockShox/Proflex
- Thread starter rva
- Start date
Retrobike93
Senior Retro Guru
Re: Replacement elastomer for Manitou 2/3/4 & Judy *NOW PROFLEX*
Hi matey,
Want to purchase elastomers for my Manitou 1 if possible , Manitou 2 fork too.
Thanks Darren
Hi matey,
Want to purchase elastomers for my Manitou 1 if possible , Manitou 2 fork too.
Thanks Darren
Retrobike93
Senior Retro Guru
Re: Replacement elastomer for Manitou 2/3/4 & Judy *NOW PROFLEX*
Hi mate , pm sent ;-)
Hi mate , pm sent ;-)
fatchanceti
Dirt Disciple
Re:
I have some on order for my son's Manitou 4 - and I'll make sure to post a full review here (where are the others?) when I receive them
I will say that the seller has been extremely responsive to messages and is great to work with. Through our conversations and swapped pics and measurements it seems that these elastomers will also work on the 1996+ Manitou Mach 5 forks as well.
Ryan
I have some on order for my son's Manitou 4 - and I'll make sure to post a full review here (where are the others?) when I receive them
I will say that the seller has been extremely responsive to messages and is great to work with. Through our conversations and swapped pics and measurements it seems that these elastomers will also work on the 1996+ Manitou Mach 5 forks as well.
Ryan
fatchanceti
Dirt Disciple
Re: Replacement elastomer for Manitou 2/3/4 & Judy *NOW PROFLEX*
Mine arrived today. They look good, and the reds are plenty soft, which is what I wanted.
yellow is an original Manitou 4 "hard", red is an rva elastomer, pink is a standard 1996 Mach 5 (I think)
They are a little heavier than the original MCUs
OD at 19mm is almost spot on to a Mach 5 unit, 3mm or so larger than a M4 original
Anyway, I'm pretty happy with these - Robert shipped them out quickly and was great to work with.
Ryan
Mine arrived today. They look good, and the reds are plenty soft, which is what I wanted.
yellow is an original Manitou 4 "hard", red is an rva elastomer, pink is a standard 1996 Mach 5 (I think)
They are a little heavier than the original MCUs
OD at 19mm is almost spot on to a Mach 5 unit, 3mm or so larger than a M4 original
Anyway, I'm pretty happy with these - Robert shipped them out quickly and was great to work with.
Ryan
Similar threads
Latest posts
-
-
Wanted Hope Bulb 135x12mm rear end cap dimensions for machining
- Latest: Gregthorne370
-
-
-
Yeti build thread. Not in the wrong section.
- Latest: Guinessisgoodforyou