Grease Monkey
Senior Retro Guru
- Feedback
- View
Vintage seatpost identify: Thomson/Ringle?
- Thread starter Grease Monkey
- Start date
Grease Monkey
Senior Retro Guru
- Feedback
- View
I'm stumped. Early Thomson Elite/ Control Tech?
American I think.
American I think.
- Feedback
- View
Did Curve make seatposts :?: :?: :?:
Grease Monkey
Senior Retro Guru
- Feedback
- View
Don't think so. It's too well tooled and the graphics look etched for an in house job.
It's definitely posh, probably had the logo anodised on the post but
long gone now. Circa 1990-93 going by the rest of the components - early
Hope screw on hubs.
It's definitely posh, probably had the logo anodised on the post but
long gone now. Circa 1990-93 going by the rest of the components - early
Hope screw on hubs.
Barneyballbags
Old School Grand Master
- Feedback
- View
ControlTech.
Grease Monkey
Senior Retro Guru
- Feedback
- View
I was thinking that too. Compared the clamp to a few Control Tech but there
a lot of intricate CNC going on here and CT look quite plain in comparison.
Any US components gurus out there
?
a lot of intricate CNC going on here and CT look quite plain in comparison.
Any US components gurus out there
?
Barneyballbags
Old School Grand Master
- Feedback
- View
Grease Monkey":31y4nqo4 said:I was thinking that too. Compared the clamp to a few Control Tech but there
a lot of intricate CNC going on here and CT look quite plain in comparison.
Any US components gurus out there
I had a CT post on an AMP B3 of mine which looked virtually identical. I don't have any photos of it otherwise I'd have posted one up
Bryncrug72
Senior Retro Guru
- Feedback
- View
I think its a control tech as well
