MORATI crankset chainring assembly
- Thread starter Yidaki
- Start date
Disco Drive
Senior Retro Guru
Hi. Where are you having the issue? Is it the washer behind the crank arm?
Disco Drive
Senior Retro Guru
He he! Thought so ;-) I had to use a slightly thinner than the normal spacer but I'm running Pace groove extruder rings. Just experiment with spacers and look out for warping of the ring.
I had one with the right outer diameter, but not the inner one.
Can't find any assembled pictures from the back that could help.
I only have 5 titanium bolts for the small chainring and 5 2-piece
bolts for the outer. Also I do posess 3.5mm spacer rings. That's it.
Can't find any assembled pictures from the back that could help.
I only have 5 titanium bolts for the small chainring and 5 2-piece
bolts for the outer. Also I do posess 3.5mm spacer rings. That's it.
Disco Drive
Senior Retro Guru
Ooh you're bringing back painful memories! ;-) the internal diameter isn't crucial as the remaining bolts will retain the alignment. You will need an extra inner chainring bolt as it's longer.
Disco Drive
Senior Retro Guru
There should be enough wall thickness on the spacer to open it out slightly?
