Dura Ace 7410 - 27.2mm - Easton Seatpost - WTD

rjsdavis

Senior Retro Guru
Feedback
View
Hi to all

Am after one of the above seatposts - would be happy to buy or swap for the same post but in 27.0mm flavour if this works for someone out there?

Must be uncut / molested, and looking for good used as opposed to NOS to keep costs down - thanks!
 
I've got a team issue cut down 7410 and I also have an as new Easton EC70 carbon..
PM me your email for photos etc if interested
 
Hi there

Thanks for the reply. Would only be interested in the 7410 pin of the two to go on a completely DA equipped bike. However, how much has it been chopped off?

Cheers!
 
It was also drilled for a cable run.
Rail to base is 20cm which gives approx 15cm above the upper drill/insertion point. Very tidy above that point. I'm over 100kg and have never had a problem with it.
Very light due to it been cut at 163g
I'd take £25 posted for it
 
tonyf39":1vehlkfn said:
It was also drilled for a cable run.
Rail to base is 20cm which gives approx 15cm above the upper drill/insertion point. Very tidy above that point. I'm over 100kg and have never had a problem with it.
Very light due to it been cut at 163g
I'd take £25 posted for it

Thanks for the info Tony - sadly, that's going to be too short for my needs.

Cheers anyway dude
 
Back
Top