Anyone bonded a metal headbadge to a bare metal frame ?
If so, what did you use ?
If it was a 'flat' badge i.e. with a large single surface area I would use silicon or similar but I fear that it could get messy with a cut away badge :
I had always understood that super glue style products really needed to etch / melt / eat into the surfaces (or at least one of the surfaces) a little to get a good bond ?
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I used Araldite for my Torus head tube badge. I've tried to lever it off (just to test strength) since and it's not budging!
Use IPA to clean first though.