raceface turbine cranks

Not Turbines, but two lovely sets of RF Next, one black, one white that i picked up for recent build. Ended up using the white on the project. :)
 

Attachments

  • img_3045.jpg
    img_3045.jpg
    130.9 KB · Views: 3,279
  • img_3063.jpg
    img_3063.jpg
    94.2 KB · Views: 3,279
wanted ...

Hi.

Not sure if this is the right place to post this wanted ad ...

I'm after a couple things please ...

A lock ring for a race face crank with the 'clover leaf' spider. Hi ... still looking for this thanks.

And a single left hand (non drive side) i beam crankarm ... 175 ... square taper ... any colour. SORTED ... found a spare crankarm thanks.

Can anyone help me out?

Thanks and thanks. Frank
 
Re: JIS or ISO

abelsfc":2rt5qwth said:
Hi, does anyone know if the square of RF Turbine is ISO or JIS? I've checked that in a JIS spindle (Shimano UN72), Alivio cranks go further into the spindle like 2 or 3mm than the Turbines. That makes me to think they are ISO, backed up due the fact that the Race Face Taperlock has ISO spindle. Could anyone confirm this? I need to get a new bottom bracket and I would like to get the appropiate one.
Thanks very much.

For the info.
My M900 cranks do not go as far onto a 107mm Taperlock as they do an UN90.

Turbine and LP cranks are designed for 'greased' tapers and as you say are 2° ISO

I can only assume the cranks are designed for the Taperlock
Sheldon on the topic of mixing
http://sheldonbrown.com/bbtaper.html
 
Turbine and Specialities T.A. rings, in my point of view the best crankset

2012-10-20_15-30-32_773.jpg
 
abelsfc":yc3pfp3m said:
ibbz":yc3pfp3m said:
Question (sorry to be a pain), on CRC would these two sets of Bolts be fine?

http://www.chainreactioncycles.com/Mode ... elID=35865 (16mm Inner x5)

and

http://www.chainreactioncycles.com/Mode ... elID=35866 (for these Outers, 8.5mm or 6.5mm??? )

Thanks.

for my Raceface Turbine 94 BCD square taper cranks and Specialites TA compact rings..

Hi,
maybe it's due to my pc, but I can't see the links.
But yes, 16mm inner will fit good on Turbine. I bought a set of aluminium ones (I cant remember the lenght) and there is a little gap to reach the top of the threads, but with the threaded part I think they are strong enough.
About the outers, I don't know what to advice you, maybe you should take as example any 3 speeds crankset.

Sorry, links stopped working.

Just wondering, are the inner bolts 8.5mm? (M8.5)

cheers
 
Back
Top