kula project

better for bike parts i find

Crank is looking nice... did you put it in the dishwasher?

No,just a manual srcub and a degrease in the parts wash using Gunk. Need to get the arm rubber boot ends on and new stickers on arms too. They are minty.

http://www.ebay.co.uk/itm/400332285619? ... 1423.l2649

these cranks seem to be quite rare as i have been searching.

Cranks now finished with new heavy duty graphics, New Ti bottom bracket, A taty raceface xy seatpost strippedand polished and refurbed ready for graphics too.

Before


Next


After




Ti BB




Seat post








Just keeping you all updated

Lookn good mate. Will it be ready for the Thetford retro-ride this year? In my opinion, the cranks can make or break a build as nice ones are hard to find, but your race face carbons with the new graphics are some of the best out there and are spot on for such a quality build. Thats going to be one sweet ride when its done.

Post finished









Well chuffed. never seen a polished XY Post

Very nice post - looks even better polished.

What seat are you going to use?

Not sure yet. Although i do have favourites, i might try something different to what i know.

Ok, So i have finally finished this kula (i think). And cant wait to give it a proper ride. It looks stunning and although very well spec'd with some light weight componants it's final REAL weight is 25.4 lbs. I dont think its a bad weight as i wasnt building a weenie anyway. Just the bike i want The wheels was the hold up but well worth the wait. They are Mavic X618 built onto Hope mono hubs and DT Swiss Revolution spokes. The 618 is the same rim as a 517 except the 618 has double eyelets. Hence slighty heavier but much stronger. I must mention than anyone around the kings Lynn area needing wheels building. Surf 55 is the bollix And i highly recomend.

Spec is mainly visible in pics but mainly consist of XTR including inner and outer cables ( i had to mention that ) Compromised with a RaceFace Next LP carbon Crank set And XY Seatpost.

Look forward to and welcome any comments/opinions.
Pics below: