Few bits needed; hope hubs, XTR bits, etc

Mindmap3

Senior Retro Guru
Feedback
View
I'm after a few bits for my 'Dale which I plan to rebuild over the winter...

Either a blue or red rear hope hub, 36 hole
Middleburn cranks
Magura HS33's in yellow or a set of M952 V's and levers
M952 XTR rear mech and shifters
70mm Thomson stem in black
27.2mm Thomson post in black

Cheers
 
what size clamp do you require for the Thomson stem, as I have a nice 70mm in 25.4mm size, c/w bag if I can find it!
 
I haven't bought any bars yet so no specific requirement. I was hoping to use a 31.8mm clamp as getting bars for 25.4mm is getting harder and harder. However, if the price is right I could be tempted!

Let me know how much you want for it and I'll let you know.

Cheers
 
Mindmap3":z32wk18a said:
I haven't bought any bars yet so no specific requirement. I was hoping to use a 31.8mm clamp as getting bars for 25.4mm is getting harder and harder. However, if the price is right I could be tempted!

Let me know how much you want for it and I'll let you know.

Cheers

how about £27.50 posted c/w bag? :D
 
Hi mate, how desparate are you to sell it? I need to see how much sorting out a new rear wheel build is going to cost me after my hub disintergrated.
 
Mindmap3":1kkpkwtm said:
Hi mate, how desparate are you to sell it? I need to see how much sorting out a new rear wheel build is going to cost me after my hub disintergrated.

oh dear, good luck with that!

not desperate, just not needed at present - just let me know? :D
 
Cheers....the sealed bearings in the free hub have totally disintegrated (inner race of the sealed bearing and even the ball bearings are all in two pieces!).

Will let you know either way.
 

Latest posts

Back
Top