dirtydozen
Gold Trader
- Feedback
- View
can you use a newer set of levers on some c2 calipers?
hope Q
- Thread starter dirtydozen
- Start date
You might be able to....
If I remember correctly, they did two systems....the closed (C2) and the open (O2). Both were the same, the only difference was the top cap of the lever; the C2 had a dial whereas the O2 had a cap with no adjuster (the same as on the DH4 and E4).
As far as I can remember, the calipers were the same. In theory, if you used a Mini lever you would convert your closed system into an open one.
I may be wrong....it might be worth trauling the net for a bot.
If I remember correctly, they did two systems....the closed (C2) and the open (O2). Both were the same, the only difference was the top cap of the lever; the C2 had a dial whereas the O2 had a cap with no adjuster (the same as on the DH4 and E4).
As far as I can remember, the calipers were the same. In theory, if you used a Mini lever you would convert your closed system into an open one.
I may be wrong....it might be worth trauling the net for a bot.
You can but you may get a lot of lever travel. There are springs in the C2 which pull the pistons back. The open system will allow the fluid to return when the pistons to retract.
I haven't tried it (yet) but I'd be interested to know how it goes. Personally I was just going to take the springs out and hope they retract enough not to rub that badly.
I haven't tried it (yet) but I'd be interested to know how it goes. Personally I was just going to take the springs out and hope they retract enough not to rub that badly.
Similar threads
Latest posts
-
Wanted Hope Bulb 135x12mm rear end cap dimensions for machining
- Latest: Gregthorne370
-
-