summitrider
Dirt Disciple
I have a Raleigh Summit in bits now, as I purchased a bigger frame and have transferred over some components.
I am not sure what to do with it now?
It's a 1993 Summit, 17" frame.
The original components on it are:
• Shimano Deore LX Front Mech
• Deore XT Thumbies, 3 and 7 Speed (But I like these and am probably going to use these on the new frame)
• Deore LX pedals, but the bearings are shot, they flop around a bit
• SLS Brake Levers
• Deore Cantilever Brakes
• Deore LX Chain Rings
• Zoom stem
• Rock Shox Mag10 (black with green stickers) brace is broken and they need a rebuild, service
• One original wheel and Hub (Front)
Replaced components are:
• FSA Pig headset, but have the original too
• Rear Mavic rim (Back) unknown model at this time, as it's buried in the garage somehwere!, which I had to replace the rear wheel when the hub seized solid, so my LBS fitted a new Deore hub and Mavic rim.
• The original Deore LX rear mech got a battering, so that was replaced with a newer LX model, but I am going to use that on the new frame.
So my question is, do I build it back to as it was before I started to change things on it a few years back, as I have all most of the original components, then sell on here as a project?
or
Do I sell all the components and frame separately?
I need to make a decision, as it's in my garage taking up space.
I am not sure what to do with it now?
It's a 1993 Summit, 17" frame.
The original components on it are:
• Shimano Deore LX Front Mech
• Deore XT Thumbies, 3 and 7 Speed (But I like these and am probably going to use these on the new frame)
• Deore LX pedals, but the bearings are shot, they flop around a bit
• SLS Brake Levers
• Deore Cantilever Brakes
• Deore LX Chain Rings
• Zoom stem
• Rock Shox Mag10 (black with green stickers) brace is broken and they need a rebuild, service
• One original wheel and Hub (Front)
Replaced components are:
• FSA Pig headset, but have the original too
• Rear Mavic rim (Back) unknown model at this time, as it's buried in the garage somehwere!, which I had to replace the rear wheel when the hub seized solid, so my LBS fitted a new Deore hub and Mavic rim.
• The original Deore LX rear mech got a battering, so that was replaced with a newer LX model, but I am going to use that on the new frame.
So my question is, do I build it back to as it was before I started to change things on it a few years back, as I have all most of the original components, then sell on here as a project?
or
Do I sell all the components and frame separately?
I need to make a decision, as it's in my garage taking up space.