Powder Coating Questions........

Coleman

Retrobike Rider
BoTM Winner
Feedback
View
Couple of questions:

1: how do you remove it? (at home)

2: anyone recommend a good place to get a frame/fork done?

Cheers

Adrian
 
I have a stem that I want to get painted and I'd like to remove an area of powder coat on the frame to see a serial number - will paint stripper work?
 
I stripped my frame last week using nitromors. Even the crappy new stuff will take it off though you'll probably find certain areas of the bike have a thicker coat so may need a few tries to strip down. I'm gonna be using garie bevan powder coatings, if you google it you should find them and they will coat stuff then post back.
 
Powder Coating

Powder coating originates from the USA and is applied as a factory finish by many established and respected marques. Long gone are the days of basic primary or muddy industrial livery-pretty much every colour in the rainbow (including chrome effect) is available now.

The quality of finish is dependant upon sprayer skill, powder used and therefore reflected in the price. An industrial “job lot” firm may charge £25 for frame and forks but in my experience, fail to mask threads, apply a layer of chromate and/or lacquer topcoat. Moreover, it is likely to be rushed through with office furniture. Sometimes you get lucky but I’ve known cases of internal cable guides melting uselessly inside the curing oven, braze-ons damaged by over zealous blasting etc.

Vastly superior are project finishers who will explain the process at each stage and the options available. Aluminium frames should only be aqua blasted to avoid extensive pitting, although minor dent/repairs are addressed before painting. This latter group commonly specialise in wet-spray techniques such as two-pac, which can be applied atop powder for some really exotic effects. Maldon Shot blasting & Powder Coating have refinished several of my framesets to a very high standard at very reasonable cost and while powder is well suited to winter/hacks Klein, Rossin and similar frequently arrive for makeover.
 
These guys in Bristol will do the lot for you as they did my Saracens :cool: http://www.realitymotorworks.com/ I cant big them up enough on quality and attention to detail. All that have seen them have been amazed at the finish. They did mention quality of powder coat and this not to be confused with industrial garden gate and farm items ......

They chemically dipped these as the super tough saracen powdercat was exactly as said :LOL: They do shot / bead blasting also.

Sulphur yellow with metal flake laquer ;) Camera does not pick up colours very well and is pretty darn bright !

Saracen006.jpg

Saracen010.jpg


Powdercoat fade with candy red / sliver and metal flake laquer which IMO is the finishing touch.

004-7.jpg

008-6.jpg
009-4.jpg


Cheers

GM :cool:
 
nevadasmith":2b85k3zw said:
I have a stem that I want to get painted and I'd like to remove an area of powder coat on the frame to see a serial number - will paint stripper work?

yes, nitromors will work fine. as a quick fix for removing only a small section of powdercoat to reveal the frame number, try applying some double sided tape (& leave the backing tape on) around the intended area. I did exactly that recently & it stopped the nitromors from spreading.
 
Powder Coat

The work looks ace. I called these guys and prices seem very reasonable. I would have to post a set of steel forks to them. Do you think they are setup to reliably post back?

Many thanks
 
Back
Top