Club Roost overhaul

Doomanic":1hprrayr said:
If you already have the measurements for the bushes, post them here and I'll get on the case.

Cant find them now :LOL:
Can re measure if you guys dont have a vernier?
 
Doomanic":3qdgw1sh said:
I couldn't bring myself to break it. :cry:

Not to worry bruv - I shall help you on that one ;)

ps - any dibs on the forks and shock anyone.....? Not sure of their value, but I have agreed with Doom that the proceeds would be split 50/50
 
I bought some batteries for the verniers today, so as soon as I have the shock (and my new coat...) I can get measuring.

cyfa> I'd still like your measurements for comparison.
 
Right, got bike out of shed, shock off.

I presume your shock came with the 'sleeve' bit. i.e a central 'shaft' on which spacers/washers sit either side?

Ok,

Top end (Main frame);
Width = approx 22.57mm
Inner diameter/bolt hole = m6
Shock sleeve hole = 12mm
Width of shock mount = approx 11.8mm

Rear end;
Width = Approx 47.45mm
Inner diameter/bolt hole = m6
Shock sleeve hole = 12mm
Width of lower shock mount (stanchion end) = approx 11.8mm


About right?
Is that enough to go on?
Dont forget there are little rubber seals before the washers go on the sleeve.
 

Latest posts

Back
Top