Club Roost overhaul
- Thread starter volvot5turbo
- Start date
volvot5turbo
Retro Newbie
Doomanic":3qdgw1sh said:
Not to worry bruv - I shall help you on that one
ps - any dibs on the forks and shock anyone.....? Not sure of their value, but I have agreed with Doom that the proceeds would be split 50/50
Right, got bike out of shed, shock off.
I presume your shock came with the 'sleeve' bit. i.e a central 'shaft' on which spacers/washers sit either side?
Ok,
Top end (Main frame);
Width = approx 22.57mm
Inner diameter/bolt hole = m6
Shock sleeve hole = 12mm
Width of shock mount = approx 11.8mm
Rear end;
Width = Approx 47.45mm
Inner diameter/bolt hole = m6
Shock sleeve hole = 12mm
Width of lower shock mount (stanchion end) = approx 11.8mm
About right?
Is that enough to go on?
Dont forget there are little rubber seals before the washers go on the sleeve.
I presume your shock came with the 'sleeve' bit. i.e a central 'shaft' on which spacers/washers sit either side?
Ok,
Top end (Main frame);
Width = approx 22.57mm
Inner diameter/bolt hole = m6
Shock sleeve hole = 12mm
Width of shock mount = approx 11.8mm
Rear end;
Width = Approx 47.45mm
Inner diameter/bolt hole = m6
Shock sleeve hole = 12mm
Width of lower shock mount (stanchion end) = approx 11.8mm
About right?
Is that enough to go on?
Dont forget there are little rubber seals before the washers go on the sleeve.
Top Bush; http://www.chainreactioncycles.com/Mode ... delID=7466
Bottom Bush; TBA
Bottom Bush; TBA
Similar threads
